Copying
2
❖When clearing entered values
Press the {Clear/Stop} key or [Clear] on the display.
❖To check the settings
Press the {Check Modes} key.
Auto Start
Copy starts automatically when the machine is ready for copy.
A Set the copy contents while “Please wait.” is displayed.
B Set the original.
C Press the {Start} key. The {Start} key lamp will flash.
Interrupt Copy
Use this function to interrupt a long copy job to make urgently needed copies.
E When the display prompts you to do so, place the former set of originals again.
F Press the {Start} key.
Note
❒The previous copy job's set- tings are restored and the machine continues copying from where it left off.
When the machine continues copying
A Place the originals you want to copy.
B Press the {Start} key.
The machine stops the previous job and starts copying the new originals.
C When copying is complete, remove originals and copies.
D Press the {Interrupt} key again.
The Interrupt indicator goes out.
Limitation
❒You cannot use Interrupt Copy when fax originals are being scanned.
A Press the {Interrupt} key.
The Interrupt indicator lights.
When scanning is interrupted
A Remove the originals that were being copied, and then place the originals you want to copy.
B Press the {Start} key.
Copying starts.
C When copying is complete, remove the originals and copies.
D Press the {Interrupt} key again.
The Interrupt indicator turns off.
The previous copy job's settings are restored and the machine continues copying from where it left off.
Left Original Beeper
The beeper sounds and an error message is displayed if you leave originals on the exposure glass after copying.
Note
❒See p.109 “Tone: Original re- mains”.
20