Sanyo KHX0952, UHX2452, UHX0752, UHX1252, UHX3652, UHX1852, THX2452, THX1252 Names and Operations

Remote Control Functions

3. Timer Remote Controller (RCS-TM80BG)

1

1

2

2

3

3

4

4

5

5

6

6

7

7

2. Names and Operations

Operation Section (Refer to the previous page)

1. Start/Stop button

Pushing this button starts, and pushing again stops the unit.

2.Operation lamp

The lamp is turned on when an air conditioner is in opera- tion.

This lamp blinks when an error occurs or a protective device is activated.

3. Mode Select button

Pushing this button to select an operation mode. (AUTO /HEAT /DRY /COOL /FAN).

4.Temperature setting buttons Changing the temperature setting.

5. FAN speed button Changing the fan speed.

6. Swing/Air direction button *1

Use this button to set the auto swing or air direction to a specifi c angle.

7. Unit Select button

When more than one indoor unit is operated by one re- mote control unit, this button is used to select a unit when adjusting the air direction.

8.Timer setting buttons

( Weekly Program Function)

9. FILTER reset button

Use this button to reset the fi lter sign.

When is displayed, press this button after cleaning the fi lter.

10. Ventilation button

Use this button when you installed a fan available in the market. Pressing this button turns on and off the fan. When turning off the air conditioner, the fan will be also

turned off.

(While the fan is operating, will appear in the display.) *If is displayed on the LCD of the remote control unit when pressing the ventilation button, no fans are installed.

11. Inspection button Do not use this button.

12. Sleeping button ( Sleeping Function)

13.Remote control sensor

Normally, the temperature sensor of the indoor unit is used to detect the temperature. However, it is also pos- sible to detect the temperature around the remote control unit.

*1 Do not move the fl ap (vertical airfl ow adjustment board) with your hand.

The fl ap is automatically directed down when the unit is stopped.

The fl ap is directed up during the HEAT standby. The

flap starts swinging after the HEAT standby is can- celled, although the AUTO fl ap indication on the remote control unit is displayed during the HEAT standby.

8

8

2-16