Sanyo XHX1252, UHX2452, UHX0752 Emergency Operation, Shutdown, Control unit will not be accepted

1

1

2

2

3

3

4

4

5

5

6

6

7

7

8

8

Remote Control Functions

2. Wireless Remote Controller

6. Emergency Operation

In any of the following events, use the Emergency operation button to operate the air conditioner on a makeshift basis.

•When there is no charge remaining in the wireless remote control unit's batteries

•When the wireless remote control unit has failed

•When the wireless remote control unit has been lost or misplaced

X type Initiate operation using the Emergency operation button in the operation area of the indoor unit.

Operation

Press the Emergency operation button.

The air conditioner initiates a cooling operation when its operation is started up at a room temperature of 75°F (24°C) or above.

Conversely, it initiates a heating operation when its operation is started up at a room temperature below 75°F (24°C).

Shutdown

Press the Emergency operation button once more.

T type Initiate operation using the Emergency operation button in the signal receiver on the indoor unit.

Operation

Press the Emergency operation button.

The air conditioner initiates a cooling operation when its operation is started up at a room temperature of 75°F (24°C) or above.

Conversely, it initiates a heating operation when its operation is started up at a room temperature below 75°F (24°C).

Shutdown

Press the Emergency operation button once more.

K type Initiate operation using the Emergency operation button in the operation area of the indoor unit.

Operation

Set the ON/OFF operation switch to “OFF” first. Then set it to “ON. ”

If a heat pump is used, the air conditioner initiates a cooling operation when its operation is started up at a room temperature of 75°F (24°C) or above or it initiates a heating operation when its operation is started up at a room temperature below 75°F (24°C).

		Shutdown
		Set the ON/OFF operation switch to “OFF.”
	• TEST is used to initiate a trial run when the air conditioner is first installed. It is not used
NOTE
	under normal circumstances.
	• To restart the wireless remote control unit's operation, the ON/OFF operation switch must
	be set to ON without fail. If it is kept at the OFF setting, the signals from the wireless remote
	control unit will not be accepted.
	2-12