Sanyo KHX1252, UHX2452, UHX0752, UHX1252, UHX3652, UHX1852, THX2452, THX1252, THX1852 TP6 TP3 TP1

Remote Control Functions

3. Timer Remote Controller (RCS-TM80BG)

Selecting the DC fan motor tap (when setting from the PCB)

●4-way Air Discharge Semi-Concealed type

<Procedure> Stop the system before performing these steps.

Open the electrical component box cover, then check the indoor unit control PCB.

Connect the jumper connector (2P: yellow) which was supplied with the accessory to the correct connector pin on the indoor unit control PCB according to the setting number which was confirmed in Table 1 (Table of DC Fan Motor Tap Settings).

•If the setting No. is (1), then connect the jumper connector to the connector pin TP1 (2P: red) on the indoor unit control PCB.

•If the setting No. is (3), then connect the jumper connector to the connector pin TP3 (2P: yellow) on the indoor unit control PCB.

White Yellow Red

TP6 TP3 TP1

●Suspended type

<Procedure> Stop the system before performing these steps.

Open the electrical component box cover, then check the indoor unit control PCB.

Connect the jumper connector (2P: yellow) which was supplied with the accessory to the correct connector pin on the indoor unit control PCB according to the setting number which was confirmed in Table 2 (Table of DC Fan Motor Tap Settings).

•If the setting No. is (1), then connect the jumper connector to the connector pin TP1 (2P: red) on the indoor unit control PCB.

•If the setting No. is (3), then connect the jumper connector to the connector pin TP3 (2P: yellow) on the indoor unit control PCB.

●1-way Air Discharge Semi-Concealed type

<Procedure> Stop the system before performing these steps.

Open the electrical component box cover, then check the indoor unit control PCB.

Connect the jumper connector (2P: yellow) which was supplied with the accessory to the correct connector pin on the indoor unit control PCB according to the setting number which was confirmed in Table 3 (Table of DC Fan Motor Tap Settings).

•If the setting No. is (1), then connect the jumper connector to the connector pin TP1 (2P: red) on the indoor unit control PCB.

•If the setting No. is (3), then connect the jumper connector to the connector pin TP3 (2P: yellow) on the indoor unit control PCB.

2-39

1

1

2

2

3

3

4

4

5

5

6

6

7

7

8

8