3Specify the video options in alarm recording.

Rate:

Configures the recording rate for the alarm recording.

The available options depend on the [Alarm area] and [Resolution] settings.

Quality:

Can change the alarm video quality setting in the camera.

Resolution:

Can change the alarm video resolution setting in the camera.

4In order to make the settings valid, select the check box corresponding to the camera.

5Click [SET].

This completes the setting procedure and the configuration is transferred to the camera.

When you configure the alarm recording for multiple cameras, repeat steps 1 to 5.

MEMO:

When the value for the [Alarm Duration] option is not selected, the alarm recording for the camera is disabled. Be sure to select the value according to the message on the dialog.

6Click [Close].

The [Alarm Setting] screen closes.

Note:

When recording on the camera’s memory temporarily

Other Buttons in the [Alarm Setting] Screen

1Select all check box

Selecting this check box in the title row selects all the check boxes corresponding to the cameras listed on the [Alarm Setting] screen.

2[Set All] button

Executes the [SET] command for all cameras.

MEMO:

When the value for the [Alarm Duration] option is not selected, the alarm recording for the camera is disabled. Be sure to select the value according to the message on the dialog.

3[Reload] button

Reloads the setting information to display.

MEMO:

While the setting information is being accessed concurrently, [Reload] button can be used to load and check the current setting information retained on the camera.

4[Copy] button

Copies the settings for the selected camera and retains them in memory.

5[Paste] button

Overrides the settings for the selected camera with the copied contents.

6[Paste All] button

Overrides the settings for all cameras with the copied contents.

Pre-alarm video may not be recorded under the following settings. Change one of the settings according to the contents in the parentheses.

Alarm area: 0.5MB (increase capacity)

Alarm Duration (Pre/Post): 10%90% (raise the ratio)

Quality: Super Fine (lower picture quality)

During alarm recording, the alarm video being received from the camera is displayed. Since there is a time lag before video is received, the displayed video will differ from the live video.

24

English

Page 25
Image 25
Sanyo va-sw3050 Specify the video options in alarm recording Rate, When recording on the camera’s memory temporarily