Sanyo VCC-6974 instruction manual Mirror setting, RS-485 setting

USING THE MENU SCREEN

OPTION/MIRROR, RS-485

EMIRROR setting

1 Press the CURSOR (l, then d or c) button to change the MIRROR setting to “H” (the setting will flash).

The image will be inverted horizontally. The image will change as described below each time the CURSOR button is pressed.

•	OFF: Normal image	•	V: Inverted vertically
•	H: Inverted horizontally	•	HV: Inverted horizontally and vertically

2When finished:

Press the CURSOR (l) button to select BACK (it will flash) at the bottom of the	OFF
screen. Then press the CURSOR (d or c) button to change BACK to END, and

press the SET button.

☞To return to the previous screen, select BACK then press the SET button.

FRS-485 setting

1 Press the CURSOR (l) button to select the RS-485 setting “SET” (the setting will flash), then press the SET button. The MENU FOR RS-485 screen will be displayed.

2Press the CURSOR (l) button so that the BAUD RATE value is flashing, then press the CURSOR (d or c) button to change the communication speed.

Note: The BAUD RATE setting should be compatible with the transmission speed of the peripheral devices.

3Press the CURSOR (l, then d or c) button to change the ALARM setting to ON (the setting will flash), then set the alarm transmission.

ON: Alarm signals are sent to the controller

OFF: Alarm signals are not sent to the controller

CURSOR	OPTION MENU
	APERTURE	ON	p
	AGC	ON
	GAMMA	ON
	ZOOM	OFF
	MIRROR	H

	H	V		HV
CURSOR	SET
		MENU	BACK
		MENU	END
CURSOR		OPTION MENU
	SET	APERTURE	ON	p
		AGC	ON
		GAMMA	ON
		ZOOM	OFF
		MIRROR	OFF
		RS-485	SET	p
CURSOR	SET	MENU FOR RS-485
		BAUD RATE	19200
		ALARM	ON

OFF

19200➞9600➞4800➞2400

56 English