PARTS NAMES

8

9

F

A G

8Camera setup section (under the cover)

To access the controls, loosen the cover fixing screw A, then remove the cover.

 

 

a b

c

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

aAddress setting switch (RS485 ADDRESS) . . . See page 57

bTerminater switch (TERMINATE) . . . . . . . . . . See page 57

c Auto iris lens switch (A. I. LENS)

See page 7

9Lens iris output connector (LENS)

This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.

FMenu setting button (SET)

Connect the camera to the monitor, then press the SET button for about 3 seconds to display the on-screen menu.

GCursor button (CURSOR)

j: Press this button to move the cursor up.

c: Press this button to move the cursor to the right, or to turn the settings ON/OFF etc.

d: Press this button to move the cursor to the left, or to turn the settings ON/OFF etc.

l: Press this button to move the cursor down.

English 5

Page 6
Image 6
Sanyo VCC-6974 Camera setup section under the cover, Lens iris output connector Lens, Menu setting button SET