Savin 5450, 3350DNP manual 190

REMARKS

•When making duplex prints or when using non-white printing paper, the pa- per end sensor might malfunction and fail to detect the paper. In this case, place a blank sheet under the printing paper on the paper feed tray.

•The outer portion of the image might not be printed under low temperature. In this case, slow the printing speed down to setting 1 or 2, or increase the room temperature.

•The paper exit pawl might contact the printing paper and cause black lines on the prints. In this case, increase the printing speed or make a new master with lighter image density mode.

•The leading edge of the prints might become stained if the edge touches the image of prints on the paper delivery tray.

•The ink of the print on the paper delivery tray might stick to the back side of the next print.

•When the machine is on and the power source is less than 90 % of the speci- fied amount, printing quality will decrease. Therefore, make sure the supply from your electrical outlet is at least 90 % of the required amount.

5 • As various kinds and qualities of paper exist, some paper might be wrapped around the drum or cause misfeeds.

•If your hands are stained with ink:

•Avoid prolonged or repeated contact with skin.

•Cleanse skin thoroughly after contact, before breaks and meals, and at the end of the work period.

•Ink is readily removed from skin by waterless hand cleaners followed by washing with soap and water.

•Also, be careful not to get any ink on your clothing while emptying the master eject unit or while loading a new ink cartridge.

•The image density varies according to the printing speed and the room tem- perature. So, adjust the printing speed or increase the room temperature.

•When you make a lot of prints from a small image, ink might ooze out from the edges of the master, especially under high temperature and when print- ing in two or more colors. In this case, make a new master.

•Use ink made within one year. Ink stored for a long period tends to dry slow- ly and yield lower image density.

•While making a master, do not leave the platen cover or optional document feeder open.

•When you store 1,000 ml/pack ink, make sure to store it upright with the cap pointing up.

•If you use originals of letters in Light or Dark Tone function, edges of the let- ters might be printed clearly and inside of the letters might become screened image.

190