Device Control

These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings.

Other Settings

Original Feeding Mode

The following original feeding modes can be set to operate by default in copy, Scan to HDD, and image send modes. When a mode is frequently used, this saves you from having to select the mode in the special modes each time you need to use it.

•Mixed Size Original (Same Width/Different Width)

•Slow Scan Mode

Saddle Stitch Position Adjust

(When a saddle stitch finisher is installed.)

When a saddle stitch finisher is installed, this setting is used to adjust the stapling position (folding position) of the pamphlet staple function.

The value can be adjusted in increments of 0.25 mm within a range of ±2.0 mm from the home position of each paper size.

Max. + 2 mm

Min. - 2 mm

Position moved in

Position moved in

the plus direction.

the minus direction.

1

12

2

11

Reference position

Auto Paper Selection Setting

The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings:

•Plain Paper

•Plain and Recycle Paper

•Recycle Paper

The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting.

*The paper type set for each paper tray using "Paper Tray Settings" (page 16) in the system settings (general).

Tandem Connection Setting

When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number and IP address of the machine used as the tandem slave machine.

Disabling of Master Machine Mode

To prohibit tandem transmission, enable this setting. (There is normally no need to enable this setting.)

Disabling of Slave Machine Mode

To prohibit tandem reception, enable this setting. (There is normally no need to enable this setting.)

• The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change the port number.

•To use the tandem function when user authentication is enabled, the same login name and password must be used on both the master machine and slave machine. If the same login name and password are not used, the page count may not be added to the appropriate user count or only the master machine may print.

Detect Standard in Auto Color Mode

When the color mode is set to auto in copy mode, the discrimination point for detecting whether originals are color or black and white can be set to one of 5 levels. To make it easier to detect a black and white original, adjust the setting toward [Black & White]. To make it easier to detect a color original, adjust the setting toward [Color].

Auto Switching of Finisher Trays

If the number of sheets on the upper finisher tray reaches the sheet limit, output will automatically switch to the lower tray.

61