Sharp XV-Z30000 appendix Resetting the Lamp Timer

Regarding the Lamp (Continued)

Securing screws

4 Remove the lamp unit.

• Loosen the securing screws from the lamp unit. Hold the lamp unit by the handle and pull it in the direction of the arrow. At this time, keep the lamp unit horizontal and do not tilt it.

5

Insert the new lamp unit.

Handle

6

•Press the lamp unit fi rmly into the lamp unit compartment. Fasten the securing screw.

Replace the lamp unit cover.

•Align the tab on the lamp unit cover (1) and close it (2). Be careful not to get the

strap caught in the cover. Then tighten the user service screw (3) to secure the lamp unit cover.

Info

•If the lamp unit and lamp unit cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

Info

•Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer and continue to use the same lamp, this may cause the lamp to become damaged or explode.

1 Connect the power cord.

•Plug the power cord into the AC socket of the projector.

2 Reset the lamp timer.

•While simultaneously holding down MENU, ENTER and R on the projector, press STANDBY/ON on the projector and keep all four buttons pressed down until the lamp indicator starts blinking green.

•“LAMP 0000H” is displayed, indicating

that the lamp timer is reset.

AC socket

STANDBY/ON button

ENTER button

Rbutton

MENU button

80