79
Appendix
Removing and Installing the
Lamp Unit
Warning!
Do not remove the lamp unit from the
projector right after use. The l amp and parts
around the lamp will be very hot an d may
cause burns or injury.
•
Info
Do not touch the glass surface of the l amp
unit or the inside of the projector.
To avoid injury to yourself and damage to the
lamp, make sure you carefully follow the
steps below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.
•
•
•
1 Press STANDBY/ON on the
projector or STANDBY on the
remote control to put th e
projector into Stand by mode.
2 Disconnect the power c ord.
Unplug the power cord from the AC
socket.
Leave the lamp until it has fully coo led
down (about 1 hour).
3 Remove the lamp unit cover.
Loosen the user service sc rew (1) that
secures the lamp unit cover. Remove the
lamp unit cover (2).
•
•
•
Lamp unit
AN-K30LP
Optional
accessory
Lamp unit
AN-K30LP
Optional
accessory
1STANDBY/ON
button
AC socket
STANDBY/ON
button
AC socket
2
3
User service screw
(for lamp unit cover)
User service screw
(for lamp unit cover)