
Raven EDGE
Tip: Use *NETALLOWZEROIP if you need to allow the display of an
IP ending in a zero.
*NETOP?
The current cellular carrier from the modemʹs firmware version, for example, your cellular provider.
*NETRSSI?
The current RSSI (Receive Signal Strength Indicator) of the
Raven as a negative dBm value.
Tip: The same information is displayed with the command S202?.
*NETSERV?
The type of service being used by the modem, for example
Tech.
*NETSTATE?
The current network state:
•Connecting To Network: The Raven is in the process of trying to connect to the cellular network.
•Network Authentication Fail: Authentication to the cellular network has failed. Verify settings to activate the Raven.
•Data Connection Failed: The Raven failed to connect, and it is now waiting a set time interval before it attempts to reconnect. Verify settings to activate the Raven.
•Network Negotiation Fail: Network connection negoti‐ ation failed. This is usually temporary and often clears up during a subsequent attempt.
•Network Ready: The Raven is connected to the 1x cellular network and ready to send data.
•Network Dormant: The Ravenis connected to the 1x cellular network, but the link is dormant. It will be woken up when data is sent or received.
•No Service: There is no cellular network detected.
•Hardware Reset: The internal module is being reset. This is a temporary state.
+ICCID
Subscriber Identity Module ID. .
|
|
|
|
|
|
|
81 |
|
|
|
|
| 20070914 |
|
|
|