Raven EDGE
Note: This mode is not available through the remote AT telnet server. You will need to connect to the Raven with it connected directly to your computer.
93
PassThru
PassThru Mode is used to communicate directly to the Raven internal hardware.
Caution: While the modem is in PassThru mode, ALEOS is disabled. If you need to connect to the Raven while it is in PassThru mode, you will need to do so with a terminal application. Not all commands are available while the modem is in PassThru mode.
Figure 1-7: AceManager : PassThru
\APASSTHRU
Sets the modem operation to pass through mode. This mode will pass any characters received on the port Ethernet directly to the internal hardware module and output any characters from the internal hardware module out the port Ethernet. This allows direct access/configuration of the hardware module. Once this mode is entered, the unit must be physically reset to return to normal operation. This command is not available in AceManager.
Note: It may take up to 30 seconds for the hardware module to respond after CONNECT is output.
*CSX1=n
PassThru Echo : Echo data to the host.
•n=0 : Data will be passed to the host.
•n=1 : PASSTHRU mode will echo all host received data and will not pass the data to the modem while the modem is not asserting DCD.
Note: If the modem is asserting DCD, data will be passed from the host to the modem as it normally is when *CSX1=0.
20070914
