WINDING BOBBIN
Be sure to use Class 15 J bobbins.
1.Place a spool of thread on the spool pin, and secure it with the spool pin cap. Pull the thread out from the spool and place it through thread guides as shown in illustration.
1
2.Put end of thread through the hole in bobbin as shown. Place bobbin onto the bobbin winder spindle as far as it can go.
3.Holding onto the end of the thread, push the bobbin winder latch against the bobbin until it clicks and bobbin starts to rotate.
4.Bobbin will disengage automatically and the winding mechanism will stop when the bobbin is full. Remove the wound bobbin and cut the thread tail.
2
3
4
12
