ATTACHING EMBROIDERY UNIT
Always be sure to turn off power to machine CAUTION before installing embroidery unit.
1.Turn off the machine.
Turn connector cap to the right to open.
2.Slide the embroidery unit onto machine fitting connectors on the machine and embroidery unit. Slide the embroidery unit as far as it will go until it clicks into place.
3.To make sure that the embroidery unit is fully engaged, hold the handle of the embroidery unit and pull it towards the left direction, checking that the embroidery unit does not detach.
Note:
If embroidery unit is not securely installed, the finished embroidery may be distorted. Make sure that the embroidery unit is pushed in as far as it will go.
Don’t push the carriage or put strong pressure on the embroidery unit while attaching or during the embroidering process. Doing so may cause
CAUTION damage to the embroidery unit.
REMOVING EMBROIDERY UNIT
*Turn off the machine.
*Remove embroidery hoop from machine. (Refer to page 70 - 71.)
1.Holding handle of embroidery unit, carefully slide toward the left while pressing release lever.
Note:
Do not pull carriage when removing embroidery unit.
2.Turn the connector cap to the left to close for general sewing.
62
1 | Connector cap |
Couvercle de connecteur |
Tapa de conector
|
| Connector |
| Carriage | Connecteur |
| Chariot | Conector |
2 | Carro |
|
|
| |
3 |
|
|
| Handle |
|
| Poignée |
|
| Mango |
|
1 |
|
|
| Release lever |
|
| Support de cerceau |
|
| Palanca de liberación | |
| Handle |
|
2 | Poignée |
|
Mango |
| |
|
| Release lever |
|
| Support de cerceau |
|
| Palanca de liberación |
