3. PREPARATION FOR EMBROIDERY SEWING
BEFORE ATTACHING EMBROIDERY UNIT
ATTACHING EMBROIDERY FOOT
Always be sure to turn off power to machine CAUTION before changing presser foot.
*Raise presser foot lifter.
*Turn the hand wheel counter clockwise (toward you) until the needle is in its highest position.
1.Remove presser foot screw, presser foot and foot holder.
2.Attach the embroidery presser foot behind presser bar so that the drive lever is above the needle clamp. Secure it by tightening presser foot screw.
3.Turn hand wheel toward you to move needle up and down, and check that the embroidery presser foot moves up and down together with the needle.
Be careful not to touch the needle when CAUTION replacing presser foot.
Foot holder
Support du pied
Sujetador prensatelas
Screw
Vis
Guia
Presser foot
Pied de biche zigzag
Pie prensatelas
| Drive lever |
Presser bar | Levier d’entraînement |
Barre de pied presseur | Palanca de accionamiento |
Barra de prensatelas |
|
Needle clamp
Abrazadera de aguja
Embroidery presser foot
Pied presseur de broderie
Prensatelas de bordado
INSERTING THE BOBBIN
Refer to page 14 - 15.
*A large amount of thread is required for embroidering, so be sure to use full bobbin.
58
