C4630 SE HOME AUDIO SYSTEM
•The remote will automatically be added to the USER.CML library.
4.Use the ADD FUNCTIONS
•If you’re creating a new remote you can use the NEW FUNCTION WIZARD to add all of the function names typical for that type of remote and use the DELETE FUNCTIONS button to delete the ones that aren’t on the remote you’re going to capture.
5.Connect the OptiLinQ IR Learner to your PC using the included USB cable. The MODE LED on the IR Learner should be RED.
6.Place the OptiLinQ IR Learner on a flat surface near your PC.
7.Place the remote control to be captured directly in front of the OptiLinQ IR Learner. The remote’s IR transmitter should be 3 – 6 inches from the IR Learner’s IR capture window.
8.Select the CAPTURE tab on the Infrared Library Manager screen (see Figure 51A, on page 38). The MODE LED on the OptiLinQ IR Learner should change to ORANGE.
Added Function Names
Appear Here
Add Functions Box/ | Delete Functions |
New Functions Wizard | Button |
Figure 50:
Adding Function Names to the Function List
9.To ensure that the remote’s IR emitter is properly aligned with the IR Learner’s IR receiver, press and hold any but- ton on the remote control for 3 seconds and verify that:
a)The SIGNAL LED on the OptiLinQ IR Learner flashes RED,
b)The IR LIBRARY screen flashes the word SIGNAL in RED and displays the IR carrier frequency of the received signal (see Figure 51B).
If a) and b) do not happen, adjust the remote’s position relative to the IR Learner and repeat Step 9.
If a) and b) do happen, press a few more buttons on the remote to ensure consistent results.
NOTE: Step 9 must be repeated every time before a new remote is captured or whenever you enter the Capture Mode.
10. Click the LEAR N button on the IR LIBRARY screen
(Figure 51C). The MODE LED on the OptiLinQ IR Learner should change to GREEN.
A:Ready to Align Remote and IR Learner
Capture Tab
B:Remote is Aligned with IR Learner
C:Ready to Learn IR Code
Figure 51:
Learning IR Codes
37
