C4630 SE HOME AUDIO SYSTEM
Zone: Assigns the C4630 SE Internal Command to a particular zone. You can assign commands to any zone being controlled by a particular C4630 SE, or to all zones.
Value: Assigns an action to the Internal Command. Values vary depending on which Function is selected.
Once you have configured the Function, Unit, Zone and Value parameters for the Internal Command, drag the icon into the Macro Window to place it in a macro (see Figure 54).
Status Test
If you want a macro command to execute only if a certain condition exists, add a Status Test command before the command in question. The following conditions can be used to determine if a macro executes: This Zone Is ON, This Zone Is Muted, Source 1 Is Selected, Source 2 Is Selected, Source 3 Is Selected, Source 4 Is Selected, Any Zone Is ON, Page Trigger Is Set.
To insert a Status Test command, select the desired condition and drag the icon into the Macro Window (see Figure 55).
Function 
Parameters
Drag Icon
Into Macro
Window
Figure 54:
Internal Command Window
Time Delay
Some audio/video components respond to IR commands more quickly than others. Adding a Time Delay after a macro command can give a component additional time to process the command and perform the required action before the next IR command in the macro sequence is sent. This can be especially useful when sending commands to
To insert a Time Delay into a macro, select or type the desired delay amount and drag the icon into the Macro Window (see Figure 56). You can set a delay of 0.1 seconds up to 240 seconds.
Select
Condition
Drag
Icon Into
Macro
Window
Figure 55:
Status Test Macro Window
Select
Delay
Time
Drag
Icon Into
Macro
Window
Figure 56:
Time Delay Macro Window
39
