C4630 SE HOME AUDIO SYSTEM
SIMULATE BUTTON PRESS Serial Commands
The SIMULATE BUTTON PRESS serial command :P (see table on page 43) can be used to allow a serial control device to trigger the macro that is programmed into any keypad button in any C4630 SE zone.
The command format is :Pzxyyy<cr>
P = Simulate button press
z = The Zone number of the command (1 – 6)
x= The command layer: 1 = PRESS, 2 =
=EXTRA COMMANDS (see Expanded Control Features, on page 47)
yyy = The keypad button to be triggered, from the table in Figure 65.
For example, to trigger the PRESS layer SOURCE 1 keypad button macro in Zone 2 the serial command would be:
:P2117<cr>
P= SIMULATE BUTTON PRESS command
2 = Zone 2
1 = PRESS layer
17 = SOURCE 1 button
Simulate Button Press Commands in Multi-Unit Systems
As with other serial commands, a SIMULATE BUTTON PRESS command can be used to control any C4630 SE in a system with multiple units by adding the C4630 SE’s Unit ID number (see page 27) to the command after the colon.
For example, to trigger the PRESS layer SOURCE 1 keypad button macro in Zone 2 of Unit #3 in a
:3P2117<cr>
3 = Unit ID #3
P= SIMULATE BUTTON PRESS command
2 = Zone 2
1 = PRESS layer
17 = SOURCE 1 button
Keypad | Button | yyy equivalent |
Numeric | 1 | 1 |
Numeric | 2 | 2 |
Numeric | 3 | 3 |
Numeric | 4 | 4 |
Numeric | 5 | 5 |
Numeric | 6 | 6 |
Numeric | 7 | 7 |
Numeric | 8 | 8 |
Numeric | 9 | 9 |
Numeric | 0 | 10 |
Numeric | – | 11 |
Numeric | + | 12 |
Main | Volume Up | 13 |
Main | Mute | 14 |
Main | Volume Down | 15 |
Main | Off | 16 |
Main | Source 1 | 17 |
Main | Source 2 | 18 |
Main | Source 3 | 19 |
Main | Source 4 | 20 |
Main | Pause | 21 |
Main | Play | 22 |
Main | Backward | 23 |
Main | Forward | 24 |
Remote | OK | 25 |
Extra Commands* | 001 – 200 | |
*See page 47 for details about Extra Commands.
Figure 65:
SIMULATE BUTTON PRESS
Serial Commands
45
