Monitoring signals during previewing During previewing, you can monitor the following video and audio signals on a monitor connected to the recorder VTR:

•Between preroll and IN points: Playback signal of the recorder VTR can be monitored.

•Between IN and OUT points: Playback signal of the player VTR can be monitored in E-E mode.

•Between OUT and post-roll points: Playback signal of the recorder VTR can be monitored.

This may be illustrated as shown below:

6-1-8 Modifying Edit Points

If an edit point is incorrectly set, for example, if an OUT point is located before an IN point, or the length of an edit section is different for the recorder and player VTRs, the time data for the incorrectly set edit point flash indicating that the VTR cannot perform editing or previewing. In this case, delete the edit point, then set a new one correctly.

You can also move an edit point position in one-frame units.

 

IN point

OUT point

$

 

 

$

 

 

 

 

 

 

 

 

 

PB

 

EE

 

 

PB

 

 

(recorder VTR)

 

(player VTR)

 

(recorder VTR)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Deleting edit points

1

2

Deleting edit points

1 Press the RECORDER or PLAYER button to select the VTR on which to perform the edit point deletion.

The button lights up.

2 Press the IN, OUT, AUDIO IN or AUDIO OUT button while holding down the CLR button to delete the corresponding edit point.

The edit point is deleted and --:--:--:-- appears in the menu display.

Editing 6 Chapter

Chapter 6 Editing 6-9