Sony manual 145

Item number	Item	Settable range		Function
722	REMOTE VIDEO	[0]	[composite]	Specifies the type of video process control via the Sony 9-
	CONTROL MODE	1	component (Y-R, B)	pin remote interface.
				0: composite (Video, Chroma, Hue)
				1: component (Y, PB PR)

					Note
					Hue cannot be controlled in component mode via 9-pin
					remote interface. Hue should be controlled by menu or by
					BVR-50.
723	INPUT VIDEO				Specifies whether the blanking is on or off during the
	BLANK				vertical blanking of video input signal.
					The blanking line can be selected independently. Y/C and
					odd/even signals are blanked simultaneously. The input
					signals blanked by specification of these sub items are
	Sub item
					recorded on tape.
	0	ALL LINE	[0]	[– – –]	0: Blanking is specified for each line.
			1	blank	1: All lines selectable by this menu item are blanked, no
			2	throu	matter what the other sub item settings are.
					2: All lines selectable by this menu item are not blanked, no
					matter what the other sub item settings are.
	12	LINE 12	0	blank	0: Blanked
			[2]	[throu]	2: Not blanked
	20	LINE 20
		(DVW-A500/1
		and 500/1)
	9	LINE 9.32	0	blank	0: Blanked
			[2]	[throu]	2: Not blanked
	22	LINE 22.335
		(DVW-A500P/1
		and 500P/1)
724	VIDEO INPUT		0	AGC	Sets the AGC to on or off (manual) for video input signal.
(with optional	AGC/MANUAL		[1]	[manual]	0: The AGC is on.
BKDW-505 for					1: The AGC is off (manual).
DVW-A500/1
and 500/1, and
BKDW-506 for
DVW-A500P/1
and 500P/1)
725	VIDEO INPUT		0	0 (HEX)	Set video input signal level when the item 724 is set to “1”.
(with optional	MANUAL LEVEL
BKDW-505 for			[80]	[80 (HEX )]
DVW-A500/1
and 500/1, and			FF	FF (HEX)
BKDW-506 for
DVW-A500P/1
and 500P/1)
726	H BLANKING		[0]	[narrow]	Sets the horizontal blanking width of the video output signal.
	WIDTH		1	wide	When analog blanking is selected, the horizontal blanking
					width conforms to the RS170A standard (for DVW-A500/1
					and 500/1) or CCIR624-3 standard (DVW-A500P/1 and
					500/1). Normally, a wide blanking width and a narrowed
					picture are used. During editing, “0”is recommended; in
					transmission, select “1”to output the signal in conformity
					with the respective standard.
					0: Digital (narrow) blanking
					1: Analog (wide) blanking

Appendix

Appendix A-29