Sony 4-4CUE Menu, 4-4-6Backspace Editing, To change an edit point into an IN point, To change an edit point into an OUT point

Settings Menu 4 Chapter

4-4 CUE Menu

4-4-5 Changing a Cue Point Into an Edit Point

Follow the procedure below to change any cue point into an edit point.

To change an edit point into an IN point Press the SET button while hoding down the IN button.

To change an edit point into an OUT point Press the SET button while holding down the OUT button.

To change an edit point into an AUDIO IN point

Press the SET button while holding down the AUDIO IN button.

To change an edit point into an AUDIO OUT point

Press the SET button while holding down the AUDIO OUT button.

AUDIO IN button AUDIO OUT button

IN button SET button

OUT button

4-4-6 Backspace Editing

You can perform backspace editing with the CUE menu. In backspace editing, assemble editing is performed from the recording end point. Since the data specifying recording end point are cleared when you eject the tape, after inserting a tape, you must record for at least one minute or so on the tape before you can do backspace editing. After recording, the present end of the recorded position becomes the recording end point. When you press the AUTO EDIT button afterwards, the VTR automatically prerolls a few seconds before the recording end point and starts assemble editing. If no data for the recording end point exist, backspace editing is not performed.

4-32Chapter 4 Menu Settings