Sony Items Related to the Audio Control (800s)

Items Related to the Audio Control (800s)

The values enclosed in a box are the factory settings.

Item number	Item	Settable range		Function
801	DIGITAL JOG	0	off	Turns the digital jog sound on or off.
	SOUND	[1]	[on]	0: Digital jog sound is turned off.
				Audio signals of digital channels for which speed
				compensation has not been conducted are output even
				in still-picture mode.
				1: Digital jog sound is turned on.
802	DIGITAL AUDIO	[0]	[off]	Sets the muting conditions for digital audio signals during
	MUTE IN	1	cueup or preroll	shuttle playback.
	SHUTTLE MODE	2	full	However, the digital audio signal is muted no matter what
				this setting is when the tape speed is 24 times normal
				speed or more.
				0: Not muted.
				1: Muted during cue-up or preroll operations.
				2: Muted in shuttle mode.
803	DIGITAL AUDIO	0	5 ms	Specifies the fade processing time during cross-fading or
	FADE TIME	[1]	[10 ms]	fading-in/out of digital audio signals.
		2	15 ms
				Note
		3	20 ms
		4	25 msa)	Processing for cross fading, fading-in, and fading-out starts
		5	50 msb)	after an IN or OUT point. This item specifies rewriting
		6	85 ms	during recording following the OUT point. Rewriting of one
		7	115 msc)	field occurs even when the minimum setting (5 ms) is
				selected. When CUT is selected in item 317 to prevent this
				from happening, a discontinuity in the audio signal occurs.
				There is, however, no effect on the recording of the video
				signal.
				a) The cross fade time is 24 ms.
				b) The actual fade time is 49 ms.
				c) The actual fade time is 114 ms.
804	AUDIO CH3/4	[0]	[CH3/CH4 : SW/SW]	Select the input signal for digital audio channels 3 and 4.
	INPUT SOURCE	1	CH3/CH4 : CH1/	0: The signal that is selected by the upper control panel is
	ARRANGE	2	SW	input to channels 3 and 4.
			CH3/CH4 : SW/	1: The signal to be recorded in channel 1 is recorded in
		3	CH2	channel 3.
			CH3/CH4 : CH1/	2: The signal to be recorded in channel 2 is recorded in
			CH2	channel 4.
				3: The signal to be recorded in channel 1 is recorded in
				channel 3 while the signal to be recorded in channel 2 is
				recorded in channel 4.
				Note
				The edit preset for channels 3 and 4 is completely
				independent. Even if this item is set to “1” and insert editing
				is performed with edit preset for channel 1 only, no signal is
				recorded in channel 3.
				The recording level is determined by the level control of the
				input channels used as the source when “1” through “3” are
				selected. There is no level control for channels 3 and 4.
				The level control for LINE OUT and MONITOR OUT is
				completely independent in E-E, CONFI and PB modes
				even when the setting is “1”, “2” or “3”.

Appendix

Appendix A-31