Settings Menu 4 Chapter

4-5 PF1 Menu (Factory Settings)4-5-1 Selecting the Input Video Signal (VIDEO IN)

Press the [F1] (VIDEO IN) button repeatedly to select the video signal to input.

sif: Serial digital video signal input to the SERIAL V/ A INPUT connector

cmpst: Analog composite video signal input to the COMPOSITE VIDEO INPUT connector

y-r/b:Analog component video signal input to the COMPONENT VIDEO INPUT connectors

4-5-2 Selecting the Reference Signal (OUT REF)

Press the [F2] (OUT REF) button to select the signal to be used as the reference signal for VTR operations.

ref: The signal input to the REF.VIDEO INPUT connector is used as the reference signal for playback and audio recording. Digital audio and video input signals must synchronize with this reference signal during recording.

input: The video input signal is used as the reference signal for VTR operations. The [F1] (VIDEO IN) button switches the video input signal.

4-5-3 Switching the Control ofthe Digital Video Processor(PROC CONTRL)

Press the [F3] (PROC CONTRL) button to select the method for operating the internal digital video processor.

menu: Select this setting when adjusting the settings of the internal digital video processor through the PF1 menu or items 715 to 721 of the VTR SETUP menu.

local: Select this setting when controlling the internal digital processor from the control panel of the VTR.

rmt: Select this setting when using the optional BVR-50 Remote Controller to remotely control the internal digital video processor.

For details on items 715 to 721 of the VTR SETUP menu, refer to Menu List on page A-28.

Note

Changing the PROC CONTRL setting during playback may cause a momentary interruption in the sound output.

4-5-4 Adjusting the Output Video Signal (VIDEO GAIN to SYSTEM SC)Adjusting the output video signal

Follow the procedure below to adjust the output video signal.

1,3 2

Adjusting the output video signal

1 Press the function button ([F4] to [F10]) whose setting you wish to set.

The setting display section lights up.

2 Change the numerical value by pressing the G or

gbutton (or + or – button).

To change the value quickly, press the buttons while holding down the SFT button.

To set the preset value Press the center cursor button.

PRST appears over the respective function button.

3 Press the function button after adjusting the numerical value.

4-34Chapter 4 Menu Settings