Starting the DASK-S704

There are two ways to start the DASK-S704 Sampling Function Sofware:

•Starting when you turn on the power of the DRE-S777

•Starting using the “GoToSample” function on the SETUP display of the DRE-S777 or DASK-S701/S702/S703 sampling reverb software

Starting the DASK-S704 by Turning on the Power of the DRE-S777

Insert the CD-ROM and the Memory Stick supplied with the DASK-S704 into the DRE-S777 and turn on the power of the DRE-S777 as follows:

1 Make sure that the erasure prevention switch at the rear of the Memory Stick is set to the left position (not the LOCK position).

Erasure prevention switch

LOCK

Note

If the erasure prevention switch is set to LOCK (right position), the Memory Stick does not operate. Be sure to set the switch to the position as illustrated above.

2 Insert the Memory Stick into the PC card adapter supplied with the DRE-S777 and insert them into the MEMORY CARD insertion slot of the DRE-S777.

With the arrow on the top-left corner

PC card adapter (supplied)

Memory Stick

3 Press the POWER switch on the DRE-S777 to turn it on.

4 Press the Z key on the DRE-S777. The CD tray opens.

(continued)

7(GB)