9 Press the F4 key.
The sampled data information is displayed.
Using the information as reference, judge if sampling should be performed again or not.
Reverb time | Period after which |
Rehearsal
Sampling
Compile
Change MS
SAMPLE
Reverb Time | = | 3.3sec |
Fadeout start = | 4.5sec | |
Noise Level | = | |
Listen impulse response?
No Exit Enter
Noise level
Tips for judgement
•If Noise Level value is between 0 and
•If Fadeout start value is more than 4.0 sec, change the Fs/Period setting on the SETUP display to Fs/11sec and perform sampling again.
Note
The Reverb Time shown may be different from the value which the hall or other reverb source place announces publically.
10Press the F4 key.
The impulse response is output, and you can confirm the compile result.
•When you do not want to listen to the impulse response, press the F2 key (No) in place of the F4 key. The reverb program name setting menu appears. Proceed to step 11.
Notes
•The impulse response output level is very high. To avoid damaging the speakers, adjust the gain of the power amplifier carefully.
•When operating with external sync, if you input a clock signal exceeding +8 % of the sampling frequency, the operation may stop or a noise may occur. In this case, input a correct clock signal and press the F3 key (Exit). Then, retry compiling from the beginning.
The following display appears when the impulse response is output.
Output level | Level meter |
|
|
|
|
|
|
| ||
|
|
| Listening | impulse | ||||
| Rehearsal | |||||||
| response | until F4. | ||||||
| Sampling |
|
|
|
|
| ||
| Compile |
|
| Output =[ | 0.0 | ]dB | ||
| Change MS |
|
|
|
|
|
| |
SAMPLE |
| PeakHold |
| Exit | ||||
|
|
|
IN |
| OUT |
1 2 | DV 1 2 | |
| 0 | |
Enter
•To adjust the output level, turn the jog dial. 0.0 to 30.0 dB can be set.
•To hold the peak value on the level meter, press the F2 key (PeakHold) to highlight the PeakHold indicator.
20(GB)