Press the F4 key.
“Go To Sampling CDROM?” is displayed in a pop-up window.
Press the F4 key.
“Please change DASK-S704 CDROM and MS” is displayed.
Starting the DASK-S704 Using the “GoToSample” Function of theSampling Reverb Software

When you use the DRE-S777 or DASK-S701/S702/S703 sampling reverb software (Version 2.0) CD-ROM, you can start the DASK-S704 from “GoToSample” on the SETUP display of the sampling reverb software.

1 Highlight “GoToSample” on the SETUP display of the sampling reverb software.

SETUP display of the DRE-S777 or DASK-S701/S702/S703

 

 

 

 

 

 

 

 

 

 

 

 

GoToSample

 

:￿

 

 

 

 

 

Licence

:￿

 

 

 

 

 

PreDelay

: ms￿

 

 

 

 

 

Serial Sel

: RS232C [

9600] ￿

 

 

 

 

Service

:

￿

 

 

 

 

 

 

 

 

 

 

 

SETUP￿ ￿

￿

 

 

Enter

 

 

 

 

 

 

 

 

 

 

2

3

4 Change the Memory Stick and CD-ROM to those supplied with the DASK-S704.

To insert/remove the CD-ROM and Memory Stick, see “Starting the DASK-

S704 by Turning on the Power of the DRE-S777” on page 7.

5 Press the F4 key.

The DASK-S704 Sampling Function Software is loaded from the CD- ROM. The loading is complete within about 3 minutes. After loading, the DASK-S704 initial display appears.

 

 

￿

 

MS:xxxxxxxx 24MB Available￿

 

 

 

 

 

Fs/Period=Fs/5.5sec￿

 

 

Rehearsal

￿

 

 

Sampling￿

 

Repeat

=16￿

 

 

Compile￿

 

Input

=AD￿

 

 

 

 

 

 

 

Change MS

 

Clock

=Internal 48.0 kHz

 

 

 

 

 

 

 

 

SAMPLE

 

 

 

Enter

 

 

 

 

 

 

 

Notes

•When a Memory Stick is changed, “Please insert MS” message may appear if the DRE-S777 cannot recognize the Memory Stick. In this case, press the F4 key again.

•If you insert a Memory Stick which is not the DASK-S704 Memory Stick, “Licence code error Please change Licence MS” is displayed. Change to the DASK-S704 Memory Stick, then press the F4 key.

9(GB)