System Connections

This section describes the typical system connections.

About the Connectors

The connectors of the system are located under the rear cover. Remove the cover to make connections, and then replace the cover again.

To remove the rear cover

Pull the rear cover toward you.

To attach the rear cover

Push the cover in while aligning the four stubs.

Preparation and Installation 1 Chapter

Connector panel (under

rear cover)

Connection Precautions

Warning

•Use only the supplied AC adapter and power cord.

•When connecting the power cord of the AC adapter and the DC cable, insert the plugs fully and securely.

•For safety, do not connect the 100BASE-TX/10BASE-T connector to a network where excessive voltages may occur.

Caution

•Before making any connections, be sure to turn power to all components off.

•To prevent damage to the unit, do not plug in or disconnect any cable while power to the unit is turned on.

System Connection via a LAN

Make connections in the order 1 - 5.

Video Communication System PCS-TL33

 

AC adapter VGP-AC19V15

 

 

(supplied)

 

3 To DC19.5V

4 Power cord (supplied)

connector

 

 

 

 

5 To AC outlet

 

 

(120 V AC)

 

1 To mouse port

Optical mouse PCS-RMU1

 

(supplied)

To 100BASE-TX/ 2

10BASE-T port

To LAN

UTP cable Category 5 (straight cable, commercially available)

System Connections 15