Videoconference Basic 3 Chapter

The line is disconnected.

Note

The power of the system remains on even if the line is disconnected.

To cancel disconnection of the system

Click “Cancel”.

To register the connected remote party in the Phone Book

You can easily register the remote party who has just disconnected.

If the “Last Number Registration” item in the Device Setup menu is set to “On”, the message “Register this participant in the list?” appears after a videoconference with an unregistered remote party is finished. When you click “OK”, the Edit List menu appears.

Notes

•If the “Last Number Registration” item is set to “Off”, the message “Register this participant in the list?” does not appear.

•If a “Memory Stick” containing Private Phone Book data is inserted, the entry will be saved in the Private Phone Book.

•If you do not click “OK” when the message appears, the message will disappear after about 30 seconds, and the remote party will not be registered to the list.

For information on the “Last Number Registration” item, see the section “Device Setup Menu” on page 25.

Joining a Multipoint Videoconference

The PCS-TL33 can join a multipoint videoconference as the child terminal to an MCU (Multipoint Control Unit). The procedures for initiating and accepting calls are the same as for a point-to-point videoconference. For details, see the sections “Starting a Conference by Calling a Remote Party” on page 48 and “Receiving a Call From a Remote Party” on page 55.

Note

Because the PCS-TL33 does not feature the MCU function, this system cannot be used to host a multipoint videoconference.

About broadcast mode

When participating in a multipoint videoconference, the video from the local system can be broadcast to all other participants.

To do this, click “Broadcast Mode” at the bottom of the menu bar, and then click “Start” in the Broadcast Mode menu.

The indicator appears at the bottom right of the screen during broadcast.

To stop broadcasting, click “Stop” in the Broadcast Mode menu.

Broadcast Mode

Self Broadcast

Start

Stop

Back

01:25

Note

To close the Broadcast Mode menu during broadcast, click the “Back” or button. To stop broadcasting, open the Broadcast Mode menu again by clicking “Broadcast Mode” at the bottom of the menu bar, and click “Stop”.

56 Joining a Multipoint Videoconference