Sony PDW-R1 manual 123

When the unit is powered on

Message in time	Display	Description	Action
data display	condition a)
MENU Ver.UP	on, limit, off	Setup menu settings were reset,	Reset the setup menu items.
		because this unit was upgraded.	See 7-2-2 “Basic Menu Operations” (page
			94) and 7-3-2 “Extended Menu Operations”
			(page 108) for information about making
			setup menu settings.
			Maintenance menu item “SETUP
			MAINTENANCE” - “SAVE MENU DATA/
			LOAD MENU DATA” (see page 113) can be
			used to temporarily back up and restore the
			current menu settings.
ILL. SETUP!	on, limit, off	Setup menu data is invalid, or data	Reset the items in the setup menu.
		recalled with the maintenance menu
		item “SETUP MAINTENANCE” –
		“AUTO BANK RECALL” is invalid.
Exchg batt!	on, limit, off	NVRAM battery is exhausted.	It is time to exchange the battery on the
			board. Contact your Sony service
			representative.
LOW BATT!	on, limit, off	Battery pack power is low.	Exchange with a charged battery pack.
BATT EMPTY!	on, limit, off	Battery pack power is exhausted.	See 3-2-3 “Using a Battery Pack” (page 33)
			for more information about exchanging
			battery packs.
a) With respect to setting of basic menu item 016

When a disc is inserted

Message in time	Display	Description	Action
data display	condition a)
Unknown FS!	on, limit, off	The loaded disc was formatted by an	Eject or format the disc.
		unknown file system.	See 3-6-5 “Formatting a Disc” (page 39) for
			more information about formatting.
No FS!	on, limit, off	The file system cannot be detected.	Eject the disc.
ILL. Disc!	on, limit, off	An unsupported disc was inserted.
Salvage NG	on, limit, off	Recovery of disc contents (salvage)	See 3-6-7 “Handling of Discs When
		failed.	Recording Does Not End Normally
			(Salvage Function)” (page 40).
525/60 Clip	on, limit	A disc recorded in NTSC format was	Use a disc recorded with the PAL system.
		inserted when this unit is in 625 line
		mode (PAL system).
625/50 Clip	on, limit	A disc recorded in PAL format was	Use a disc recorded with the NTSC
		inserted when this unit is in 525(U) or	system.
		525(J) line mode (NTSC system).
IMX50 Clip	on, limit	The recording format of the loaded disc	To record on the disc, change the setting of
IMX40 Clip		differs from the format specified with	basic menu item 031.
IMX30 Clip		basic menu item 031 “RECORDING	See 7-2-2 “Basic Menu Operations” (page
DVCAM Clip		FORMAT.”
			94) about how to change this setting.

Troubleshooting and Maintenance 8 Chapter

8-4 Alarms 123