SpectraLink Corporation

Link WTS Installation and Operation

13.6Connect the OAI Telephony Gateway to the Application Server

Using a standard 9-pin female D-type connector, connect the serial port on the front panel of the OAI Telephony Gateway to the PC, application server, or modem that will be used to interface with the application.

The OAI Telephony Gateway uses the following pins on the connector:

Pin

Function

2Data OAI Receives

3Data OAI Transmits

5Ground

If the application is up and running, the RD and SD LEDs on the front panel of the OAI Telephony Gateway should be lit or blinking, indicating that the OAI Telephony Gateway is sending and receiving data to or from the PC.

13.7 Assign A Function Key to OAI Telephony Gateway

To access the OAI application, the user presses FCN and an assigned number key. Follow these steps to assign a function key to inititate the OAI application.

1.Make sure a Link Wireless Telephone is registered to line 2. This is the only port with administration access.

2.With the system up and running and within range of a Base Station, move the Mode switch on the MCU to the ADMIN position.

3.Press START on the Wireless Telephone registered to line 2. You should hear a steady tone.

4.Press the FCN key followed by the key you want to assign for OAI access.

5.Press ##555, then press END. This assigns OAI to the specified key.

6.Return the MCU Mode switch to the NORM position.

Part Number: 72-0075-01-C-W.doc

Page 49

Page 60
Image 60
SpectraLink 150 M3 MCU manual Connect the OAI Telephony Gateway to the Application Server