I Check

I Possible remedy

Are you tryingtofeed paper using the front panel buttons while the ON LINE indicator is illuminated?

rI the paper toothick?

You can only feed paper in this way when the printer is off-line. Set the printer off-line and then feed paper.

There are limits to the thickness of paper that can be fed in this way (one top copy and two NCR copies). Try using thinner paper.

If the ASF is not operatingor is not feeding paper correctly,check the following:

Check

Possibleremedy

Has theASF optionbeen

Selectthisoption.

selectedwith the DIP

 

switch?

 

Isthereleaseleversettothe

Thereleaselevershouldbesettothesingle-sheet

~ position?

position.

Is the ASF correctlyMakesurethattheASFispmperlyseatedontheprinter. mounted?

Ispapercaughtup near the

pint head?

Are the left and right guides too close together?

Is there too much paper in the paperfeedhopperorstacker?

Was the paper fanned before being fed into the ASF?

Has the paper been used al- ready or is it creased?

Are you trying to feed paper using the front panel buttons

while the ON indicator is illuminated?

Stop printing, remove the j ammed sheet (you may have to remove the ASF for this), and continue.

If the left and right guides are too close together, the paper will not feed smoothly. Move them a Iittlefurther aw to abv the paper to feed freely.

The ASF’S paper feed hopper and stacker can hold 50 sheets each. Make sure that there is no more paper than this in either the hopper or stacker.

If this is not don% paper jams may occur. Remove the stack of paper horn the ASF and fan it before reinsert- ing.

Only new, uncreased paper should be used with the ASF.

You can only feed paper in this way when the printer is off-line. Set the printer off-line and then feed paper.

Is the paper too thick or too thin?

There are limits to the thickness ofpaperthat can be fed in this way. Try using different paper.

Page 101
Image 101
Star Micronics LC-20 user manual Check Possibleremedy