One thing to remember about defining proportional characters: a character cannot be wider than the specified width. That seems obvious enough! For example, if you specify a width of 6 for a character (starting in column 1 and ending in column 6), the seventh through eleventh columns of dots (if you specified any) will not print. You must, however, send information (even if it is 0) for those columns when you defined a character; SR- lo/15 expects eleven characters following the < ESC > “*” 1 nl n2 mO or the < ESC > “8~” CHR$(O) nl n2 mU sequence.

In most cases, the width you select should actually be one dot wider than the number of columns that the character actually occupies. This is so that there will be a space (of one dot) between characters when you print them. If you specify a width which is exactly the same as the number of columns in the character definition, the characters will touch when they print (this is sometimes desirable--for border characters or for large download characters that are more than eleven dots wide).

Table 9-l

Download character commands

Function

 

 

Mode

Control code

 

Define download character

STAR

<ESC>

* 1 nl n2

 

 

 

 

m0 ml...mll

 

 

 

 

IBM

< ESC >

“8~” CHR$(O)

 

 

 

 

nl n2 m0 ml...mll‘

Copy ROM to download

STAR

<ESC>

“*” 0

RAM

 

 

IBM

<ESC>

“:” 0 0 0

 

 

 

Download

characters

ON

STAR

< ESC >

‘3”

1

 

 

 

IBM

<ESC>

“%”

1 0

Download

characters

OFF

STAR

< ESC >

‘3” 0

 

 

 

[IBM~~ 1 < ESC >

“%” 0 0

W Connecting characters

As we noted earlier, it’s possible to connect proportional width characters. This can be useful for creating logos or other char- acters which are larger than one normal character. It also makes it possible to create connecting scripts, like handwritng. The trick to this is to specify the width in the attribute byte to be exactly the same as the number of columns of dots that the character (or partial character) occupies. And, if you change the vertical spacing to 7/72” (use the < ESC > “1” command), you can make characters connect vertically. This allows you to make very large characters indeed!

__-

97

Page 107
Image 107
Star Micronics SR-10/I5 user manual Download character commands Function Mode Control code