Sun Microsystems X6250 manual Proceed to Updating the Critical Server-Specific Drivers

13.Press either Enter to select Express Setup, or C to select Custom Setup.

If you created a RAID volume on your boot disk as part of your prerequisite preparations for installing Windows, press C to select Custom Setup and manually partition the disk. Make sure to reserve a minimum of 200 MB of unpartitioned space at the end of the drive. Otherwise, press Enter to select

Express Setup.

14.Follow the on-screen instructions to complete the initial setup of Windows Server 2003 until you are prompted with the following message:

Remove disks or other media. Press any key to restart.

When this message appears you will need to complete one of the following steps, depending on which driver delivery method you have chosen, to complete the installation:

■Floppy Disk Local: Remove the floppy disk from the floppy drive attached to the server.

■Floppy Disk Remote: Remove the floppy disk from the JavaRConsole server.

■Floppy Image (only supported for server modules using ILOM): Deselect Floppy Image from the JavaRConsole Devices menu.

Then, press any key to restart the system and complete the Windows Server 2003 Installation.

15. Proceed to Chapter 8 “Updating the Critical Server-Specific Drivers.”

36 Sun Blade X6250 Server Module Windows Operating System Installation Guide • September 2008