Symantec 7 manual Pd.conf file settings, Debuglog

Configuring deduplication 61

Editing the deduplication configuration file

4Save and close the file.

5Restart the NetBackup Remote Manager and Monitor Service (nbrmms) on the host.

pd.conf file settings

Table 5-4describes the deduplication settings that you can configure.

	Table 5-4	pd.conf file values
Setting	Default value	Possible values	Action
DEBUGLOG	C:\pdplugin.log	Any path	Writes the log information to the specified file.
	(Windows)		Uncomment the DEBUGLOG line that corresponds
	tmp/pdplugin.log
			to your operating system and then specify the
	(UNIX)		log file path. You can specify a different location
			and log file name.
LOGLEVEL	0	0 through 10	Specifies the amount of information that is
			written to the log file. The range is from 0 to 10,
			with 10 being the most logging.
			Note: Do not change this setting unless directed
			to by a Symantec Technical Support
			representative.
COMPRESSION	0	0 (off) or 1 (on)	Specifies whether you want compression. By
			default, files are not compressed. If you want
			compression, change the value to 1.
			See “About compression and encryption”
			on page 28.
ENCRYPTION	0	0 (off) or 1 (on)	Specifies whether you want encryption. By
			default files are not encrypted. If you want
			encryption, change the value to 1.
			See “About compression and encryption”
			on page 28.
PREFETCH			This keyword is reserved for internal use.
			Note: Do not change this setting unless directed
			to by a Symantec Technical Support
			representative.