TANDBERG 5000 If an output is ‘Off’, no audio will be sent to that output, Level Settings Outputs

VISION 5000 Videoconferencing System Advanced use

Audio Outputs

============= Outputs =============

Out1:Off On

Out2(AUX): Off On

Out3(VCR): Off On Level Settings

Previous Menu

Audio out 1 is intended for connection to Tandberg Natural Audio module, televisions or audio amplifiers with loudspeakers.

Audio out 2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The signal is a mix of audio from both the remote and local side (not from Audio in 5).

Audio out 3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio from remote side and local side (not from Audio in 6).

NOTE

Never connect audio out 2 or audio out 3 to a loudspeaker placed in the same room as the microphones connected to the system. Doing this will cause “howling” and possible damage to the speaker system.

If an output is ‘Off’, no audio will be sent to that output.

Level Settings - Outputs

========= Level Settings =========

Out1:	—— +13.5dB
Out2(AUX):	——	+13.5dB
Out3(VCR):	——	+13.5dB
Previous Menu

Adjust the audio output levels according to the parameters of the external audio equipment connected. These levels should be adjusted when installing new audio equipment only. The default settings are correct for the Tandberg Natural Audio module and for most consumer electronics devices (televisions, CD-players, VCRs, etc.).

The audio output levels specify the maximum level of the output.The audio outputs are adjustable in steps of 1.5 dB from 0 dB to 22.5 dB.

The volume control on the remote control will control the level of output 1 (the speaker output). The volume control will have no effect on output 2 and 3.

55