TANDBERG 5000 user manual RS366 Dialling Leased Line Data Triggered Manual, RS449/V35 Compatible

Advanced use VISION 5000 Videoconferencing System

External network settings

==== External Network Settings ====

Call Control:

RS366 Dialling Leased Line Data Triggered Manual

Network Clocking:

RS449/V35 Compatible

X21 Compatible

Advanced Network Settings

Previous Menu

IMPORTANT

The physical interfaces on External Networks are two non-standard 44 pin connectors. Special cables are required.

Before using the system together with external network equipment, you must specify the network parameters on this page.

Note

The system has support for up to 384/512/768 kbps using External Network (RS449/V.35/X.21) interface depending on software version.

Call control

‘RS366 Dialling’ is the only dialling protocol and would normally be used together with network clocking ‘RS449/V35 Compatible’ when the external equipment uses RS366 ports.

‘Leased Line’ is a non-dialling protocol and should be used when only two codecs are connected in a point to point connection. Use ‘Leased Line’ when handshake signals DTR and CD are available. DTR and CD correspond to the X21 network’s C and I signals.

‘Data Triggered’ mode uses TxData (transmit data), RxData (receive data) and clock signals only. Use ‘Data Triggered’ when no handshake signals are available.

‘Manual’ should be used when no handshake signals are available, and the external equipment requires a constantly connected line.

70