The slowest slope is set by the value “5.”
•GAIN: The output level of the signal processed by the compressor/expander.
•ATTACK: The time the processed signal takes to achieve the specified ratio after the input signal exceeds the threshold (compressor) or falls below the threshold (expander).
8 − Effects
•RELEASE: The time the processed signal takes to return to unprocessed after the input sig- nal falls below the threshold (compressor) or exceeds the threshold level (expander).
6Use F4 (SW) to turn the dynamics processor on and off.
7Press ENTER to confirm these settings.
Effect libraries
The
The EQ library and dynamics library each feature a preset library that stores preset data and a user library that can store
The EQ and dynamics libraries are each divided into two categories: a preset library that contains preset data, and a user library that can store
Recalling library data
Follow the steps below to recall stored preset data or user data.
1While the EQ setting screen (or dynamics setting screen) is displayed, press and hold the ENTER key for at least one second.
The
Figure 8.5: EQ library screen
Figure 8.6: Dynamics library screen
NOTE
To return to the EQ setting screen (or dynamics set- ting screen) while the EQ library screen (or dynam- ics library screen) is displayed, press the CANCEL key.
2Move the cursor to the desired library data you want to recall.
3Press the F2 (LOAD) key.
The
Storing library data
You can store the current effect settings as user data.
1While the EQ setting screen (or dynamics setting screen) is displayed, press and hold the ENTER key for at least one second.
The
NOTE
To return to the EQ setting screen (or dynamics set- ting screen) while the EQ library screen (or dynamics library screen) is displayed, press the CANCEL key.
2Move the cursor to the library data location to which you want to store the current settings.
NOTE
You cannot store the settings to the preset data location.
3Press the F1 (SAVE) key.
The
TASCAM