7–Playback
Searching forward and backward

 

Adjusting the playback volume

 

 

 

During playback or when stopped (or paused), press and hold the Ô/button to search backward/forward. Release the button to return to the previous state.

Use the CUE/REVSPEEDitem on the SETUPscreen to set the search speed. (See “System settings (SETUP)” on page 83.)

Press the Ô/button briefly to search backward/ forward to the beginning/end of the file.

Press the same button again briefly to change the search speed. The speed options are: x2, x5, x10, x20, x40 and x120.

NOTE

Searching backward/forward continues only until the beginning/end of the current file. Searching will not continue into the previous or next file even if you continue to hold the button.

Use the OUTPUT (+/–)buttons to adjust the volume level output from the built-in speaker or the /LINE OUT jack. While being adjusted, the volume level is shown in a pop-up at the bottom of the display.

NOTE

If you turn the MIC/LINE input off, the playback level returns to its original level.

If the MIC/LINE input is on, and you have used the BALANCE button to lower the volume of the playback (BALANCE)

to overdub an audio file, when you play back that file, the playback monitoring level will be lower than it was when recording. In this case, use the BALANCE button to set BALANCEto its maximum.

62TASCAM LR-10