Remove and Replace
6-34 WFM90D and WFM91D Service Manual
Remove. Toremove the turnlock stud receptacle:
1. Remove the bottom cover.Refer to Bottom Cover on page 6--31.
2. Depress theretaining fingers on the turnlock stud receptacle and push the
receptaclethrough the bottom cover. See Figure 6--16.
Remove. Toreplace the turnlock stud receptacle:
1. Push the turnlock stud receptaclethrough the bottom cover. Be sure the
retaining fingerssnap into position. See Figure 6--16.
2. Install the bottom cover.Refer to Bottom Cover on page 6--31.
Remove. To remove the electrical shield:
1. Remove the bottom cover.Refer to Bottom Cover on page 6--31.
2. Pry up the electricalshield on the inside of the bottom cover around the
edges and peel it offof the bottom cover.
3. If necessary,clean the surface of the bottom cover to remove any remaining
glue residue.
Replace. Toreplace the electrical shield:
1. Peel the protectivecovering off the adhesive surface of the electrical shield.
2. Position the electricalshield above the inside of the bottom cover and align
the hole in the shield with the hole in the bottom cover.
3. Press the shield onto thebottom cover and rub the shield to make sure it is
securely in place.
4. Install the bottom cover.Refer to Bottom Cover on page 6--31.
TurnlockStud ReceptacleBottom Cover ElectricalShield