4 Replacement Procedure

4.26 Fluorescent lamp

4.26.3 Replacing the 14.1 Inch XGA TMD Fluorescent lamp

The following describes the procedure for replacing the fluorescent lamp (See Figure 4-63 to Figure 4-74)

Disassembling Fluorescent lamp

Peeling off the tapes and insulation sheets

1.Flip the module over and place it on a flat surface that is free of foreign objects.

2.In the order (1), (2), and (3) shown in Figure 4-63, remove the tape for fixing the FL tube cable, two pieces of tape on the bezel that are close to the FL tube, and the X- PCB insulation sheet.

CAUTION: (1) Be careful not to damage the TAB.

(2) Leave the insulation sheet on the bezel to allow the reuse of the sheet.

Product label

F9402

3

>PC-GF13<Label (cautions for disposal of FL tubes)

BL S/N label

CAUTION label

1

2

2

 

 

Figure 4-63 Replacing 14 Inch TMD fluorescent lamp (1)

4-80

Satellite A40 Maintenance Manual (960-458)

Page 346
Image 346
Toshiba A40 manual Replacing the 14.1 Inch XGA TMD Fluorescent lamp, Disassembling Fluorescent lamp