4.26 Fluorescent lamp

4 Replacement Procedures

11. Stick the protection cover S (A), fixing tape (C), fixing tape for lead wire (D).

Fit the cover according to the outline of the screw.

Stick to the side of the bezel.

Make sure the lead wire is closely attached to the bezel.

Fit the cover according to the outline of the screw.

(A)

 

 

 

 

 

 

 

 

 

0 to 1 mm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(D)

 

 

(C)

 

Do not make the tape over the

 

 

 

 

 

 

 

 

top of the module.

 

 

 

 

 

0 to 0.5 mm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The tape MUST NOT appear on the display.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Stick the tape according to the outline of the

 

 

 

 

 

 

 

 

module. Make sure the tape does not appear

 

 

 

 

 

 

 

 

on the side of the module.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Stick the fixing tape at the center of the module.

Figure 4-152 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (24)

Satellite A40 Maintenance Manual (960-458)

4-147

Page 298
Image 298
Toshiba A40 manual Replacing 15.0 Inch Sharp fluorescent lamp SXGA+