4.26 Fluorescent lamp

4 Replacement Procedure

Setting the bezel

1. Start installing the bezel in the upward direction until it stops at the top left corner.

CAUTION: The GND-CU and lamp reflector on the left-hand side must not go beyond the edges of the bezel.

Be careful not to damage the cables and TAB.

The bezel latches must be engaged (there are five latches on the top edge, and two latches on the bottom edge).

Next, fit the bezel’s edge

 

次にた TAB側をはめる .

 

close to theラ ッチTAB5か所. をはめる .

 

Close the five latches.

2

2

2

2

2

1

TheND-foldCU折ofり曲GNDげ有 り -CUベゼルの外に出ない こ と . must not go beyond the

The fold ofリ フreflectorレ ク タ折 りmust曲げ有notり . go beyond theベゼbezel’sルの外に出edgeない.こ と

First, fit the bezel’s edge close to the

ベゼルを ランプ側か らはめる .

lampケーブ. Useをキcareズつけnotないtoよ うdamageに注意 the bl

ラ ッチ 2箇所有 り .

Two latches

Figure 4-72 Replacing 14 Inch TMD fluorescent lamp (10)

Satellite A40 Maintenance Manual (960-458)

4-89

Page 355
Image 355
Toshiba A40 manual Replacing 14 Inch TMD fluorescent lamp