Toshiba A40 manual Replacing 14 Inch TMD fluorescent lamp

4.26 Fluorescent lamp 4 Replacement Procedure

Attaching the tapes and insulation sheet

1.Attach the PCB insulation sheet (one point).

2.Attach the tape for the bezel to the bottom area close to the lamp (two points).

3.Attach the tape for fixing the FL tube cable (one point).

CAUTION: When attaching tape and insulation sheet, be careful not to damage the TAB and lamp cable connections.

	Attaching the insulation sheet
1	1

Attach the sheet after removing slack.

The frame must not be ＰＣＢが フレームに

乗overlaidり上げて無withい こtheと PCB.

Align the sheet with the reflector's edge.

Align the sheet with the module's edge.

Attach the sheet by pressing it so that the bezel may not "fly".

Align the sheet with the reflector's edge.

2

2

The tape edge must not protrude from the surface モジ ュール表面に出ない こ と of the module.

Align the sheet with the module's edge.

モThジeュtーapeル表e面dにge出musない こt noと t protrude from the surface of the module.

Attaching the tape for the bezel ベゼルテープ貼 り付け

Requirements for attachment: The tape edge must not go beyond the bezel's貼 り基準edge： .

ベゼル端か ら出ない こ と

e5

Requirements for attachment: 貼Theり基準tape： edge must not go

beモジyondュール端を目the安に貼module'sるedge. Rubber cap: Must cover the opening for the cable.

Figure 4-74 Replacing 14 Inch TMD fluorescent lamp (12)

Satellite A40 Maintenance Manual (960-458) 4-91