Manuals / TP-Link / Computer Equipment / Network Router

TP-Link TL-ER604W Session Limit, Limited Bandwidth, Effective Time, Down, Description, Status

Models: TL-ER604W

1 159

Download 159 pages 47.9 Kb

Page 71

Limited Bandwidth

Limited Bandwidth	Specify the Limited Downstream Bandwidth for this entry.
(Down):
Effective Time:	Specify the time for the entry to take effect.
Description:	Give a description for the entry.
Status:	Activate or inactivate the entry.

List of Rules

You can view the information of the entries and edit them by the Action buttons.

The first entry in Figure 3-40indicates: The users within group “group1” share the bandwidth and the Downstream/Upstream Guaranteed Bandwidth is 5000kbps, while the Downstream/Upstream Limited bandwidth is 10000kbps. This entry takes effect at 8 a.m. to 10 p.m. from Monday to Friday.

Note:

●The premise for single rule taking effect is that the bandwidth of the interface for this rule is sufficient and not used up.

●It is impossible to satisfy all the guaranteed bandwidth if the total guaranteed bandwidth specified by all Bandwidth Control rules for certain interface exceeds the physical bandwidth of this interface.

3.4.3 Session Limit

The amount of TCP and UDP sessions supported by the Router is finite. If some local hosts transmit too many TCP and UDP sessions to the public network, the communication quality of the other local hosts will be affected, thus it is necessary to limit the sessions of those hosts.

3.4.3.1Session Limit

On this page, you can configure the session limit to specified PCs.

Choose the menu Advanced→Session Limit→Session Limit to load the following page.

-66-

Image 71

TP-Link TL-ER604W Session Limit, Limited Bandwidth, Effective Time, Specify the time for the entry to take effect, Down

Contents

Wireless N Gigabit Broadband VPN Router TL-ER604WCE Mark Warning COPYRIGHT & TRADEMARKSFCC STATEMENT Chapter 1 About this Guide CONTENTSAdvanced Appendix A Hardware SpecificationsChapter 4 Application GlossaryThe following items should be found in your package Package Contents One TL-ER604W Router  One Power Adapter  One RJ45 Ethernet Cable  Quick Installation Guide  Resource CD1.2 Conventions SymbolChapter 1 About this Guide 1.1 Intended ReadersChapter 2 Introduction  Powerful Data Processing Capability Wireless Feature  Powerful Firewall Easy-to-use 2.2 Features Flexible Traffic Control  Dual-WAN PortsSecurity WirelessTraffic Control Status 2.3 Appearance2.3.1 Front Panel  LEDs2.3.2 Rear Panel  Reset button Wifi button  Power3.1.1 Status Chapter 3 Configuration3.1.2 System Mode 3.1 NetworkChoose the menu Network→System Mode to load the following page Figure 3-2 Network Topology - NAT ModeFigure 3-3 Network Topology - Non-NAT Mode Figure 3-4 Network Topology - Classic Mode Classic Mode 3.1.3.1 WAN Mode NAT Mode  Non-NAT Mode1 Static IP  WAN Mode3.1.3.2 WAN1 Tips Static IP Host Name 2 Dynamic IP Dynamic IP Connection TypeServer Get IP Address byUnicast Use the following DNSSecondary DNS Displays the IP address of your ISP’s Secondary DNS 3 PPPoEGateway Address Displays the Gateway Address assigned by your ISP Primary DNS Displays the IP address of your ISP’s Primary DNSSettings  PPPoE SettingsPassword Active ModeSubnet Address Service NameISP Address Secondary ConnectionPrimary DNS Gateway Address4 L2TP IP Address L2TP Settings the obtained DNS is displayed Default GatewaySecondary ConnectionIP Address  L2TP Status5 PPTP StatusConnection Type  PPTP SettingsServer IP PasswordConnection Type Default Gateway Primary DNS Secondary DNS Upstream BandwidthActive Mode Secondary ConnectionIP Address  PPTP Status6 BigPond Status BigPond Settings IP Address  BigPond StatusDefault Gateway Status LAN 3.1.4 LAN3.1.4.1 LAN 3.1.4.2 DHCP DHCP Settings  DHCP Reservation 3.1.4.3 DHCP Client3.1.4.4 DHCP Reservation Set the MAC Address for WAN port 3.1.5 MAC Address List of Reserved Address Set the MAC Address for LAN portPort 3.1.6 Switch3.1.6.1 Statistics  MAC AddressTips 3.1.6.2 Port Mirror Statistics Port Mirror Enable Port MirrorGeneral Mode Rate Control 3.1.6.3 Rate ControlApplication Example Port 3.1.6.4 Port Config Port Config  Port VLAN 3.1.6.5 Port Status3.1.6.6 Port VLAN  Wireless Setting 3.2 Wireless3.2.1 Wireless Setting 3.2.1.1 Wireless SettingMode  Wireless ParameterAP Isolation SSIDDescription SSID Broadcast2 WPA/WPA2 or above. Enter 0 to disable the updateGroup PeriodPeriod 3 WEPor above. Enter 0 to disable the update GroupTips 3.2.1.2 Multi-SSIDKey Format Hexadecimal and ASCII formats areSSID  Multi-SSID Config General Specify a name for the wireless networkSSID Enable/DisableGuest Network AP IsolationPeriod EncryptionGroup Key PasswordGroup Auth TypeHexadecimal and ASCII formats are provided . Hexadecimal format or above. Enter 0 to disable the updateTips 3.2.1.3 WDS List of Group TipsKey Type Scan Parameter BSSIDto be bridgedShort GI 3.2.1.4 Wireless Advanced Wireless Advanced Key ：Fragmentation 3.2.2 MAC FilteringBeacon Interval RTS Threshold General 3.2.3 Host Status Filtering Rules  Rule List General 3.3 User Group3.3.1 Group  Host Status List of Group  Group Config User Config 3.3.2 UserView  View Config3.3.3 View  List of User NAPT 3.4.1.1 NAT Setup3.4 Advanced 3.4.1 NAT One-to-One NAT 3.4.1.2 One-to-One NAT list of Rules 3.4.1.3 Multi-Nets NAT List of Rules  Multi-Nets NATApplication Example Network Requirements Configuration procedure3.4.1.4 Virtual Server Status  Virtual ServerInterface Protocol List of Rules 3.4.1.5 Port Triggering Port Triggering  List of Rules 3.4.1.6 ALGStatus FTP ALG 3.4.2.1 Setup3.4.2 Traffic Control  ALGLimited Default LimitControl Control all the timeDirection Guaranteed Bandwidth3.4.2.2 Bandwidth Control  Bandwidth Control RuleEffective Time 3.4.3 Session Limit3.4.3.1 Session Limit Limited Bandwidth3.4.3.2 Session List Enable SessionCheck here to enable Session Limit, otherwise all the Session Limit entries will be disabled3.4.4.2 Policy Routing 3.4.4.1 Configuration3.4.4 Load Balance Select the WAN port for transmitting packets  General General 3.4.4.3 Link Backup List of Rules Failover WAN Config3.4.4.4 Protocol Timing List of Protocol 3.4.5 Routing3.4.5.1 Static Route  Protocol List of Rules  Static RouteApplication Example 3.4.5.2 RIP General  List of RIPChoose the menu Advanced→Routing→RIP to load the following page Gateway 3.4.5.3 Route TableDestination The Destination of route entry General 3.5 Firewall3.5.1 Anti ARP Spoofing 3.5.1.1 IP-MAC BindingStatus 3.5.1.2 ARP Scanning IP-MAC Binding IP Address3.5.1.3 ARP List 3.5.2 Attack Defense Defense Enable AttackFlood Defense Packet Anomaly MAC Filtering 3.5.4 Access Control3.5.3 MAC Filtering 3.5.4.1 URL FilteringMode  URL Filtering RuleObject  GeneralApplication Example Network Requirements 3.5.4.3 Access RulesConfiguration Procedure 3.5.4.2 Web FilteringSource  Access RulesService PolicyDestination 3.5.4.4 Servicegroup on 3.3.1 Group PriorityDest. Port  Service List of Service NameApplication 3.5.5 App Control3.5.5.1 Control Rules  Control Rules List of Rules 3.6 VPN3.5.5.2 Database 3.6.1.1 IKE Policy 3.6.1 IKE IKE Policy Remote ID 3.6.1.2 IKE ProposalLocal ID Remote ID Type IKE Proposal  List of IKE Proposal 3.6.2 IPsec3.6.2.1 IPsec Policy  General  IPsec PolicyPolicy Name Local SubnetRemote Gateway Policy Mode IKE Mode Remote SubnetAH Authentication Key-Out  Manual ModeAH Authentication Key-In ESP Authentication Key-InTips 3.6.2.2 IPsec Proposal List of IPsec Policy IPsec  IPsec Proposal List of IPsec Proposal Protocol Authentication3.6.3 L2TP/PPTP 3.6.2.3 IPsec SAProtocol 3.6.3.1 L2TP/PPTP Tunnel L2TP/PPTP Tunnel  GeneralPre-shard Key TunnelMax Connections L2TP/PPTP Server IP Address Pool  List of Configurations3.6.3.2 IP Address Pool 3.6.3.3 List of L2TP/PPTP Tunnel3.7.1.1 General 3.7 Services3.7.1 PPPoE Server  General Figure 3-70 General The following items are displayed on this screen IP Address Pool 3.7.1.2 IP Address PoolStatic IP Address 3.7.1.3 Account Account IP Address AssignedStatus is 48. If Enable Advanced Account Features is not selected, the3.7.1.4 Exceptional IP  List of AccountStatus 3.7.2 E-Bulletin3.7.1.5 List of Account  Exceptional IP General Interval E-Bulletin TitleObject 3.7.3 Dynamic DNSPublisher  List of E-Bulletin Dyndns DDNS 3.7.3.1 DynDNS No-IP DDNS 3.7.3.2 No-IP List of DynDNS Account  PeanutHull DDNS 3.7.3.3 PeanutHull List of No-IP Account  List of PeanutHull Account 3.7.3.4 Comexe List of Comexe Account 3.7.4 UPnP Comexe DDNS  List of UPnP Mapping 3.8 Maintenance3.8.1 Admin Setup 3.8.1.1 Administrator Administrator 3.8.1.2 Login Parameter General 3.8.1.3 Remote Management Remote Management Configuration Procedure 3.8.2.1 Factory Defaults3.8.2 Management  List of Subnet Export 3.8.2.3 Reboot Configuration Version 3.8.2.2 Export and Import3.8.3 License 3.8.2.4 Firmware UpgradeDisplays the interface 3.8.4 Statistics3.8.4.1 Interface Traffic Statistics  Interface Traffic StatisticsPackets Tx 3.8.4.2 IP Traffic StatisticsPackets Rx Displays the number of packets received on the interface IP Traffic Statistics 3.8.5 Diagnostics3.8.5.1 Diagnostics  Traffic Statistics General 3.8.5.2 Online Detection Ping  Tracert List of WAN status 3.8.6 TimePing DNS LookupSystem Time Config3.8.7 Logs Current TimeSend System Logs  Config List of Logs Severity4.1 Network Requirements Chapter 4 ApplicationTips 4.2 Network Topology 4.3 Configurations4.3.1 Internet Setting 4.3.1.1 System Mode4.3.1.2 Internet Connection 4.3.1.3 Link Backup4.3.2.1 IPsec VPN 4.3.2 VPN Setting1 IKE Setting SettingsClick the Add button to apply Figure 4-4 IKE Proposal  IKE PolicySettings Tips 2 IPsec Setting IPsec Proposal SettingsproposalIPsec1 you just created  IPsec PolicySettings Tips 4.3.2.2 PPTP VPN Setting IP Address Pool L2TP/PPTPEnable ProtocolPPTP ModeServer UsernamePPTP Passwordabcdefg  L2TP/PPTP TunnelSettings  User 4.3.3 Network Management4.3.3.1 User Group  GroupSettings 4.3.3.2 App Control View 2 Interface Bandwidth 1 Enable Bandwidth Control4.3.3.3 Bandwidth Control Settings 4.3.3.4 Session Limit3 Bandwidth Control Rule Settings1 Scan and import the entries to ARP List 4.3.4 Network Security4.3.4.1 LAN ARP Defense Settings 4.3.4.2 WAN ARP Defense2 Set IP-MAC Binding Entry Manually 3 Set Attack Defense4.3.4.3 Attack Defense 2 Statistics 4.3.4.4 Traffic Monitoring1 Port Mirror Figure 4-23 IP Traffic Statistics General Appendix A Hardware SpecificationsEnvironmental and Physical WirelessAppendix B FAQ 4. Make sure that the NAT DMZ service is disabled data authentication, and anti-replay services. ESP encapsulates Appendix C GlossaryGlossary AH （Authentication Header ）Description for services such as IPSec that require keys. Before any IPSecGlossary Description Glossaryenterprise GlossaryDescription