TL-ER604W supports both RIPv1 version and RIPv2 version, thus you can configure the RIP version based on the actual need to improve the network performance.

Choose the menu Advanced→Routing→RIP to load the following page.

Figure 3-48 RIP

The following items are displayed on this screen:

General

Interface: Displays the interfaces which has been physically connected or assigned static IP.

Status: Enable or disable RIP protocol.

RIP Version: Select RIPv1 or RIPv2. RIPv2 supports multicast and broadcast.

Password If RIPv2 is enabled, set the Password Authentication according to the actual Authentication: network situation, and the password should not be more than 15 characters.

All Interfaces: Here you can operate all the interfaces in bulk. All the interfaces will not apply RIP if “Enable” option for All Interfaces is selected.

List of RIP

After RIP is enabled, the information of RIP forwarding the packets received by the Router will be displayed in the list.

The first entry in Figure 3-48indicates: when receiving packets with destination IP is 116.10.20.28, the Router will select WAN1 which is in the same network with the destination IP as next hop and forward

-75-

Page 80
Image 80
TP-Link TL-ER604W manual RIP Following items are displayed on this screen,  List of RIP