Unitech MS860 manual Buzzer, Introduction, One High Tone Beep, One High-Low-High Beep

INTRODUCTION

Buzzer

The MS860 provides audible feedback while it is in operation. These sounds indicate the operating status of the scanner.

One High Tone Beep

The scanner will beep once after successfully reading a bar code.

One High-Low-High Beep

After scanning a ‘begin configuration’ bar code (“Enter Group 5”, for instance), the scanner LED will flash green while the scanner simulta- neously gives one high-low-high tone beep. Upon exiting configuration mode by scanning an “Exit” bar code, the scanner will give one high tone beep, and the scanner LED will stop flashing.

Continuous High-Low Beeps

If scans are attempted out of range, communication will be broken. The scanner LED will remain red and you will hear a continuous high- low beep from the scanner when you scan bar codes.

If the Access Point is powered off, this means the communication between the scanner and the Access Point is lost. You will also hear a continuous high-low beep from the scanner when you scan bar codes.

MS860 WiFi Manual 6