
CONNECTIONS
1Remove approximately 10 mm (3/8 in) of insulation from each of the speaker cables.
10 mm (3/8 in)
2Twist the exposed wires of the cable together to prevent short circuits.
3Loosen the knob using the supplied speaker terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
4Insert one bare wire into the hole on the side of each terminal.
Red: positive (+)
Black: negative (–)
5Tighten the knob to secure the wire using the supplied speaker terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative
6Hook the speaker terminal wrench onto WRENCH HOLDER on the rear panel of this unit when not in use.
14