3Press MAIN ZONE ON/OFF, ZONE 2 ON/OFF or ZONE 3 ON/OFF on the front panel (or POWER on the remote control) to turn on this unit, Zone 2 or Zone 3.
POWER
ON/OFFor
Front panel | Remote control |
y
•When MASTER ON/OFF is pressed inward to the ON position, you can also press POWER or STANDBY on the remote control to turn on or set this unit, Zone 2 and Zone 3 to the standby mode simultaneously.
•For details about controlling Zone 2 and Zone 3 using the remote control, see page 104.
Note
MAIN ZONE ON/OFF, ZONE 2 ON/OFF and ZONE 3 ON/OFF on the front panel as well as POWER and STANDBY on the remote control are operational only when MASTER ON/OFF is pressed inward to the ON position.
4Press MASTER ON/OFF on the front panel again to release it outward to the OFF position to turn off this unit.
This unit, Zone 2 and Zone 3 are turned off.
MASTER
ON 
OFF 
CONNECTIONS
Setting the speaker impedance
Follow the procedure below to change the impedance setting for all speakers.
CAUTION
If you are using 6 ohm speakers, set the impedance to 6 ohms before using this unit.
1Press MASTER ON/OFF on the front panel to release it outward to the OFF position to set this unit, Zone 2 and Zone 3 to the standby
mode.
MASTER
ON 
OFF 
2Press and hold STRAIGHT (EFFECT) on the front panel and then press MASTER ON/OFF inward to the ON position to turn on the
power of this unit.
SP IMP.–8ΩMIN appears in the front panel display.
STRAIGHT
MASTER
ON 
OFF 
EFFECT
ADVANCED SETUP
SP IMP.-8 MIN
3Press STRAIGHT (EFFECT) on the front panel repeatedly to select the impedance of
your speakers.
STRAIGHT
EFFECT
• Select 6 ohms if you are using 6 ohm speakers.
4Press MASTER ON/OFF on the front panel to release it outward to the OFF position to save the new setting and set this unit, Zone 2 and Zone 3 to the standby mode.
This unit will be set to the standby mode.
MASTER
ON 
OFF 
Note
You can also set the speaker impedance by using the SP IMP. parameter in the ADVANCED SETUP menu (see page 88).
PREPARATION
29
