Yamaha HTR-5990 Fm/Am, Memory MAN’L/AUTO FM, Tuning Mode AUTO/MAN’L, Display, Volume, Pure Direct

CONTROLS AND FUNCTIONS

7FM/AM

Switches the reception band (FM or AM) when TUNER is selected as the input source (see page 44).

Note

The frequency of the previously received station is automatically recalled.

8A/B/C/D/E

Selects one of the 5 preset station groups (A to E) when TUNER is selected as the input source (see page 48).

9PRESET/TUNING/CH l / h

Selects the preset station number (1 to 8) when TUNER is selected as the input source and the colon (:) is displayed next to the band indication in the front panel display.

Selects the tuning frequency when TUNER is selected as the input source and the colon (:) is not displayed in the front panel display.

See pages 44 to 49 for details.

0Front panel display

Shows information about the operational status of this unit.

AMEMORY (MAN’L/AUTO FM)

Stores a station in the memory when TUNER is selected as the input source. Hold down for more than 3 seconds to start automatic preset tuning (see page 45).

BTUNING MODE (AUTO/MAN’L), DISPLAY

Switches the tuning mode between automatic (the AUTO indicator is turned on) and manual (the AUTO indicator is turned off) when TUNER is selected as the input source.

CVOLUME

Controls the volume level of all audio channels.

Note

This does not affect the OUT (REC) level.

DOPTIMIZER MIC jack

Use to connect the supplied optimizer microphone to run AUTO SETUP (see page 30).

E PHONES (SILENT CINEMA) jack

Outputs audio signals for private listening with headphones.

Notes

•When you connect headphones, no signals are output at the PRE OUT jacks or to the speakers.

•All Dolby Digital and DTS audio signals are mixed down to 2- channel stereo (front left and right channels).

FSPEAKERS A/B

Turn on or off the set of front speakers connected to the SPEAKERS A and/or B terminals on the rear panel each time the corresponding button is pressed.

GPURE DIRECT

Turns on or off the PURE DIRECT mode (see page 39).

Note

The indicator around the button lights up when the unit is in the PURE DIRECT mode.

HSTRAIGHT (EFFECT)

Turns the sound field programs on or off. When STRAIGHT is selected, 2-channel or multi-channel input signals are output directly from the respective speakers without effect processing.

IPROGRAM selector

Use to select sound field programs or adjust the balance of bass and treble in conjunction with TONE CONTROL.

JTONE CONTROL

Use to adjust the balance of bass and treble for the front left and right and center channels (see page 36).

KAUDIO SELECT

Toggles the priority for the type of audio input jack between AUTO, HDMI, COAX/OPT and ANALOG when one component is connected to two or more input jacks on the rear panel (see page 41).

LINPUT selector

Selects the desired input source.

MMULTI CH INPUT

Selects the input source connected to the MULTI CH INPUT jacks. When selected, the MULTI CH INPUT source takes priority over the input source selected with the INPUT selector (or the input selector buttons on the remote control).

NZONE CONTROL

Switches the zone you want to control between the main unit, Zone 2 and Zone 3 (see page 104).

After you press ZONE CONTROL, the indicator for the currently selected zone flashes in the front panel display for approximately 5 seconds. While the indicator is flashing, perform the desired operation.

OVIDEO AUX jacks

Input audio and video signals from an external source such as a game console. To reproduce source signals at these jacks, select V-AUX as the input source.

6